|
carter wgd carb
|
||||
|---|---|---|---|---|
|
Quite a regular
 
|
Hi I'm rebuilding my carburetor and not sure of what the float height should be and should it sit almost in the bottom of the bowl when empty
Posted on: 2015/5/5 18:33
|
|||
|
||||
|
Re: carter wgd carb
|
||||
|---|---|---|---|---|
|
Quite a regular
|
Its a Daytona kit and only shows the level of 7\32 but nothing of the float drop wasn't sure if anybody knew what it should be
Posted on: 2015/5/5 21:52
|
|||
|
||||
|
Re: carter wgd carb
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
My rebuild info for the WGD (which is not a Packard document) does not show a specification for float drop.
Posted on: 2015/5/5 22:33
|
|||
|
||||
|
Re: carter wgd carb
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
See page 9 in the Fuel & Exhaust section of the 1951-54 service manual that is available on this site.
Clearance between the top surface of the float and the bowl cover should be 13/64 inch with the cover inverted and the needle valve seated.
Posted on: 2015/5/6 2:11
|
|||
|
||||
