band shafts
|
||||
---|---|---|---|---|
Home away from home
|
what is the best metal to use for these, and the pins
got it out ok,,then it broke,
Posted on: 2015/9/6 18:56
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
How about a grade 8 bolt?
Posted on: 2015/9/6 19:50
|
|||
|
Re: band shafts
|
||||
---|---|---|---|---|
Forum Ambassador
|
I'd think about making them from oil-hardening drill rod.
Posted on: 2015/9/6 20:09
|
|||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
I like ross's fix,, he does use g8 bolt, but uses spacers no groove, which is a good point, that groove weakens the shaft,,its in the middle too boot......
dave I will get some drill rod too, and see how it is.
Posted on: 2015/9/6 21:34
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
had a g8 bolt
Posted on: 2015/9/7 2:17
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
chrome moly another option, but they don't have it in 3/8s,
going with the g8 bolt, if, Packard would of used the shaft for low,brake, think they would be ok, its, 1/2 inch, the reverse is 3/8s, then you have that groove, not enough room in case to ream out to 1/2 inch/ spacers to center lever, see what I have around here ,,hot roll should be ok, might have 3/4 stainless, to get fancy, could put needle thrust washers on the sides,,,,
Posted on: 2015/9/7 15:41
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
shaft spacers,, broke end mill trying to slot shaft,,so put it in lathe,,it for roll pin
Posted on: 2015/9/7 21:12
|
|||
Riki
|
||||
|
Re: band shafts
|
||||
---|---|---|---|---|
Home away from home
|
band shaft,,chrome molly,,didn't want the yellow or black finish to rub off, that is on the g8 bolts and get in oil.
Posted on: 2015/9/11 18:29
|
|||
Riki
|
||||
|