Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
oops "right" is now "top"
Posted on: 2020/7/26 11:49
|
|||
|
Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
The electric S-W system uses ordinary holes and arms are held on by a barrel type nut. The right and left bottom two arms resemble Clipper thru 47 but may be too short. Clipper arms have a total length of just over 12" and the hole is 3/16" in diameter. I believe the windshield is not quite as wide or the arm posts quite as far apart on the 110-120 electric models so if the arms are shorter than 12" possibly one of those cars.
Posted on: 2020/7/26 12:34
|
|||
Howard
|
||||
|
Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The length info is helpful - these are about 9" from base center to rivet at end of arm. The lower two are set with barrel nuts. Do they mount into a similar socket as the other two?
My car is the conventional body, and vacuum. But the spacing should be the same as 120-110 electric since the cowl is the same.
Posted on: 2020/7/26 13:55
|
|||
|
Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
My wiper system seems to be working now, but the right side wiper doesn't (although turning under the dash). Is the arm splined for removal? There is a threaded hole in the top for some reason, unless it's used for the arm removal. That is screwing a bolt in there to push the spline off. I hesitate to do much, other than loosening the retaining nut, for fear of breaking it. I've included a photo. Thank you for whatever help anyone is able to offer.
Posted on: 2020/8/17 14:46
|
|||
|
Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
To fix the floppy wiper, experimenting, I found that threading a short screw into the hole on the top of the wiper arm bottom, actually allowed it to work. The only other change is I may replace the weakened spring with a stiffer one in the wiper arm. The photo shown does not have that screw in place, but I put in where what looks like a collar on the wiper arm resides.
Posted on: 2020/8/22 10:28
|
|||
|
Re: windshield wipers for 41
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
No clue if the conventional body electric wiper setup differs significantly from the Clipper version used thru 47 but here is some info and photos for the Clipper style.
The blade has a hole that fits down over the shaft and is held by a threaded cylinder with a screwdriver slot on one end. That acts much like a barrel nut and screws onto the shaft pressing the blade down onto the shaft. The cylinder nut is .345 or 11/32 -- just shy of 3/8 long by .235 or 1/64" shy of 1/4 inch. The shaft has serrations on the bottom which slide into the blade hole but I don't see any definitive matching serrations in the blade for them to grab onto. The screwdriver slots on the cylinder nut are flush with the blade housing when assembled.
Posted on: 2020/8/22 12:54
|
|||
Howard
|
||||
|