Re: 55 400 steeting column
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Check the bearing around the shaft at the very top of column. 55s used the same setup as earlier so see if there is a round ring around the shaft and sort of nestled down inside the bearing. It may be thin stamped steel friction fit & slipped over the shaft or it may actually be a round split snap ring in a groove around the shaft. At any rate, if you find one remove it because it can prevent the column from lifting.
Posted on: 2013/6/29 12:50
|
|||
Howard
|
||||
|