Re: Heater valve capillary tube
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
There were some changes in location. Check out this counselor article, page 105https://www.packardinfo.com/xoops/html/downloads/SC/SC-VOL21NO22.pdf and see if it is applicable to your car.
Packard changed to a different valve with a different tube sometime after production started so it may not be applicable. On your square plenum cover or box, is there a small opening air can blow out anywhere. Later units thru 56 had a rectangular hole where the warm air would blow directly on the tube.
Posted on: 2013/10/11 8:36
|
|||
Howard
|
||||
|
Re: Heater valve capillary tube
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks Howard, That's exactly what I needed. My glove box does have the clips installed on it to secure the tube. I just noticed those clips two days ago, and was thinking that they were there to hold wires in place.
Jeff
Posted on: 2013/10/11 11:25
|
|||
|