Re: 37 Packard Front Clip Alignment Issues
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Looks like you have two issues. The top photo may indicate a sprung hood. This appears to be common among our Packards; when the hood is propped open, its weight will work to bend the sheet metal along the line that forms the familiar Packard Ox yoke radiator shape. The results are much worse if someone aggressively throws the hood open to rest on the opposite hood side.
My 39 was the same way and the fix was to gently work the bend in the original direction. To do so, I placed wood 2x4 cut to correct length from radiator support to cowl to support the feature and repeatedly pressed the outer hood down to undo the bend. For the second photo, keeping the rod nuts at the same location is not enough. If all the clip bolts were loosened, then it may be that the top of the radiator surround has moved to the passenger side. To check, stand about 5-10 ft in front of the car and see if the hood ornament, front windshield divider post and rear window divider all line up. If not, loosen whatever clip bolts you must, such as those connecting the radiator surround to the fenders. Then, push the surround to the driver side, making sure the rod adjustment nuts will let you. Do this until the ornament and dividers line up. Once this is the case, the rod nuts can be brought up to uniformly adjust the gap of the hood to the surround. Finally, if the gaps on the side of the hood at the cowl and again at the surround are not uniform, then the surround is at the incorrect height and may need to be raised or lowered with washers or rubber mounts. Once I went through all of this on my 39, it came out very well, but not perfect. I hope this helps. By the way, great color. I say that since my appears to be exact same. Pat
Posted on: 2014/12/5 15:40
|
|||
|
Re: 37 Packard Front Clip Alignment Issues
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thank you very much Pat for taking the time to help me with my problem. I only separated the clip from the cowl and running boards, I left the clip fenders and radiator surround bolted in place. I think if I loosen the cowl and running board bolts and loosen the radiator bolt hopefully I can make some adjustments. This is what a fellow Packard friend advised. What do you think ??
Posted on: 2014/12/5 16:00
|
|||
|