Re: Heater Core Box Removal
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
I believe you will have more sheet metal screws facing the firewall -- at least the later models do and if the heater has never been off before and the screws left out those are probably what is holding the top on. If that is the case you will have to remove the entire heater assy from the firewall to gain access to those screws. If you can't see any more screws, the two halves are sometimes tite or have some sealant between the core and covers that may have gotten gummy and are holding things together. The blower attachment on the bottom may also have a screw or flange which is preventing the separation.
If you do have to remove it, the entire assy is held by 4 studs thru the firewall with nuts on the passenger side. That arrangement sandwiches the firewall between the heater and the air distribution plenum. The nuts are inside the plenum and are accessed by removing the plenum outer cover. The cover may be held by bent over tabs or screws. There may also be a sheetmetal screw thru a bracket on the engine side as well as another attaching the blower motor ground wire. Once the fresh air supply hose is off, wires and water hoses disconnected and the studs free, the entire heater and blower assy should lift out as a unit. Check for any bowden cables attached. I don't think there are any to the heater directly but If yours is an early car the thermostat sensing capillary may be inside the plenum so watch for that. You might check some of the Chevy truck vendors for an original looking water valve. Also some of the plumbing supply houses. You need 3/8 pipe to 5/8 hose. If you cannot find one that looks similar to the original thru one of those vendors then universals are available thru most parts stores. The universals are shorter than the original so you may also need to get a male to female 3/8 pipe extension or adapter to raise the valve up so hoses clear the manifold a bit better.
Posted on: 2015/5/11 17:16
|
|||
Howard
|
||||
|
Re: Heater Core Box Removal
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
you might check restoration supply for the valve
Posted on: 2015/5/11 20:12
|
|||
|
Re: Heater Core Box Removal
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thank you very much for the detailed instructions/advice.
This forum is really a great asset!!! Bill
Posted on: 2015/5/17 11:24
|
|||
Bill,
Dedicated to keeping the man who owns one on the road!!! |
||||
|