Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Can you post a pic of the entire bell housing? I would like to see the entire bolt pattern to get a better idea.
Posted on: 2015/7/25 7:12
|
|||
[url=https://packardinfo.com/xoops/html/modules/
|
||||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
That particular location is pointed out in the shop manual for receiving a special self locking bolt and no star washer for that very reason. The self locking bolt has probably been installed elsewhere in the bellhousing pattern and can be identified by the cross scored head.
If you don't have the correct bolt, put the present one back without the star washer and with a good sealant.
Posted on: 2015/7/25 7:15
|
|||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Aside from the special bolt the torque specs for the aluminum case transmission were not updated. They were using the same torque for the aluminum as for the iron.
This makes them highly susceptible to stripping. So I always used a 10lbft lower torque with blue Loctite and gasket sealer on the bell housing.
Posted on: 2015/7/25 7:35
|
|||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Hi Troy. Find below photos as requested... Warren.
Posted on: 2015/7/25 7:46
|
|||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Hi Ross. You are absolutely correct... The bolt is there but in the wrong location... Thanks for the assistance... Much appreciated.
Posted on: 2015/7/25 8:05
|
|||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Thanks Tim. I wasn't aware of the torque difference for the aluminium case... Good advice. Thanks to all for the good advice... Very much appreciated.
By the way, when removing the pushbutton actuator from the side of the transmission, I didn't have a small scissor type jack as posts elsewhere on this forum have advised to use to push the trans across to enable removal, so I improvised and used a turnbuckle to pull it across instead. It worked really well and was quick and easy to install... May be of assistance to others as an alternative to the jack method.
Posted on: 2015/7/25 8:16
|
|||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Great, that is exactly where I was going. I did not see the locking bolt but wanted to see the entire bolts to verify. Ross hit it on the head, Very important to follow the Manual step by step.
Switch these two bolts.
Posted on: 2015/7/25 9:44
|
|||
[url=https://packardinfo.com/xoops/html/modules/
|
||||
|
Re: Ultramatic fluid leak
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Thanks Troy - thanks all.
Posted on: 2015/7/25 17:46
|
|||
|