Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Webmaster
|
I had to do this to install a new (uncut) cylinder I got for my trunk lock on my '54 (same cylinder as 55s).
Just lifting the wire legs did not release the cylinder. I had to remove the wire and replace it afterward. Sorry, I don't have any pictures from that procedure, that was pretty early on in my resto.
Posted on: 2016/11/9 10:55
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Home away from home
|
I got the lock cylinder out of the casing. I have not been able to track down a new lock cylinder or lock assembly, so I guess I am just stuck with using a screwdriver to open the truck latch. Bummer ...
Posted on: 2016/11/15 11:07
|
|||
You can make a lot of really neat things from the parts left over after you rebuild your engine ...
|
||||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Forum Ambassador
|
please post picture of backside of lock cylinder - either I have one, or someone will.
DAF
Posted on: 2016/11/15 11:24
|
|||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Home away from home
|
Here is a link to an article from a Packard service article about the lock cylinder:
packardinfo.com/xoops/html/downloads/SC/SC-VOL29NO12.pdf If you need a photo of case and lock cylinder, I can get you one tonight.
Posted on: 2016/11/15 11:42
|
|||
You can make a lot of really neat things from the parts left over after you rebuild your engine ...
|
||||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Forum Ambassador
|
very hard to discern the actual from the illustration. yes, please post picture of backside of your cylinder.
DAF
Posted on: 2016/11/15 12:58
|
|||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Home away from home
|
OK, I will do that this evening.
Posted on: 2016/11/15 14:31
|
|||
You can make a lot of really neat things from the parts left over after you rebuild your engine ...
|
||||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Home away from home
|
Here is a photo of the inside end of the lock cylinder.
Posted on: 2016/11/19 18:24
|
|||
|
Re: Removing Lock Cylinder
|
||||
---|---|---|---|---|
Webmaster
|
Check with Joel Ray. He may have them. Also, if you can find one off a parts car, you can stick your existing key in, file the tumblers down as needed, and bingo. You have a working trunk lock. I did the same with my glovebox lock.
Posted on: 2016/11/21 10:45
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|