Re: OD Pics
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Perhaps someone can take a couple of full straight on shots of the dash and firewall in an OD equipped car for you as I don't have any. Until then, here are a couple of partials showing the relay location and the knob location.
I believe the knob is under the drivers side ashtray or perhaps a bit more to the right. There should be some factory holes in the bottom of the dash where the bracket would mount. The relay would probably need the holes drilled in the firewall at the approximate location shown in the photo. The kickdown sw mounts approx 18" and almost directly under the relay in the round hole in the lower firewall bracket for the accelerator pedal linkage.
Posted on: 2017/6/17 13:05
|
|||
Howard
|
||||
|
Re: OD Pics
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
There are dimples in the firewall just for drilling the holes for the relay. There are already holes in the bottom edge of the dash to hold the cable bracket.
Posted on: 2017/6/17 18:29
|
|||
|
Re: OD Pics
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I'm still trying to get my overdrive sorted out so I have a lot of pics on my project blog starting here Overdrive. My overdrive kickdown switch was missing so I am using a universal one.
Below is a pic showing the lockout knob location.
Posted on: 2017/6/18 8:29
|
|||
[url=h
|
||||
|
Re: OD Pics
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks guys! I think these will work just fine
Posted on: 2017/6/19 18:24
|
|||
Even the most difficult situations can be learning situations.
1953 Packard Clipper 1957 Chevrolet BelAir 2004 Chevrolet Corvette |
||||
|