Re: Opening behind battery
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
It is to help keep the battery cool. There should be a weather seal around it to seal to the back of the battery.
Posted on: 2018/10/13 13:23
|
|||
|
Re: Opening behind battery
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks for the quick reply! Very interesting... I'll make sure that's sealed up then once I get the battery in.
Thanks again!
Posted on: 2018/10/13 13:24
|
|||
|
Re: Opening behind battery
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
The side of the battery is exposed to the air thru the opening and the seal consists of a strip of L shaped rubber around the opening on the upper part of the inner panel plus (on a 47) a section which is fastened on the bottom portion of the inner panel to complete the rectangle. The battery side presses against the extended rubber lip to form the seal. The inner panels may be slightly different on later models but I believe the seal was essentially the same on all Clipper based bodies 41 thru 50.
I was unable to find any short lengths of L shaped rubber available at retail in the correct size for all dimensions but there is a square U channel available from McMaster-Carr and maybe MSC or others that is the correct 1/8 thickness. McMasters number is 8507K47. By ordering a 10' length of the channel and cutting off the "B" leg of the U shown in the illustration the remaining L shape is almost the perfect size to match the original. The original rubber was stapled to the metal but other ways will be needed to fasten the new rubber to the inner fender if you need to replace the seal. 10' is enough to replace all rubber on the 47 inner fenders but unsure on the later cars since the inner panels are a bit different. Here is a photo of a 47 fender and while the inner panels may vary on the 49 I believe the rubber configuration and mounting is the same.
Posted on: 2018/10/13 14:37
|
|||
Howard
|
||||
|
Re: Opening behind battery
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Great info! Thanks a ton for the help, I'll have to check out the condition of my rubber if it exists and then check out those sources for replacement.
Posted on: 2018/10/13 15:37
|
|||
|