Packard Forum Index » Pre-War (1899-1942)

I have had the vent window out for quite some time trying to replace the rubber moulding. My auto is a Model 1591-2050 Chassis 2055 which has the large rear vent window. Finally had to piece two pieces together from a '41 to get a suitable one. In the process, I lost the top pivot piece that holds the top of the window in place. At a loss of what it looks like and wondering if anyone can help me out to find one or make one. Not sure how it attaches to outside moulding frame as there are just three holes. I think it must be kind of a small bracket with a center screw which screws into the vent window frame and then perhaps has two prongs which hold it in place on the main moulding frame. I am just guessing at this point. Sure could use your help!!
Lee Noga tel # (509)967-2723

If there's a vent window on the other side could you look at that to see what the top pivot piece looks like and how it's attached? Good luck.

Lee (auto.nut), my English isn't good enough to understand every detail or it is the champagne, that makes his contribution. If not the one below, then be so kind to say which drawing you need by using more simple words, please.

One of these? I must admit though that the drawings aren't intended for a 1591-2050 chassis 2055 but they help maybe nevertheless.

Attach file:

---

  (29.08 KB)


  (20.93 KB)

HAPPY NEW YEAR definitely the champagne!

Steve (packardguy53), definitely the champagne! Happy new year!

Attach file:

---

  (35.84 KB)