Packard Forum Index » Pre-War (1899-1942)

Hi All,

After all these years I finally acquired a set of sidemount covers for my 34 Packard. I am looking for some advise on using these. From what I read the cover that goes over the tire holds the outer cover in place, if so what stops this from rattling loose?

My wheel covers do not have any rubber. I had a look at Steele rubber, but they didn't list anythiung specifically. I did however read side mount cover pads for a 1936 Buick fit. Can anyone confirm this, or have suggestions what to use instead?

Also, I am missing the metal trim for these. These I'm guessing would be rare to find, but if anyone has any leads on remakes I would appreciate it.

Cheers,
Mat

Attach file:

---

  pacwheelcover.png (2,331.31 KB)