Re: 3 Pin Brake Light Switch
|
||||
---|---|---|---|---|
Home away from home
|
Have you put a meter across the brake circuit of the switch and tested it?
You can also test it by raising the back of the car with the levelizer and then shutting off the suspension at the under dash switch. The swap the brake and suspension wires at the 3 pin switch. Now the brake lights should be on and go off when you press the brake pedal and when you switch the suspension back on, it will only go back to level when you keep your foot pressed. on the brake pedal. Next would be fluid pressure to the switch. When you bled the brakes, did you bleed the switch? You could also pick up a 2 pin brake light switch and see what happens. Next would to be to put a pressure gauge at the switch location and see what you have by way of pressure.
Posted on: Today 5:02
|
|||
|