|
1938 Rear hub nut
|
||||
|---|---|---|---|---|
|
Just popping in
 
|
Hi,
Is there a torque setting for the rear hub nut? Thanks. Roger
Posted on: Yesterday 13:49
|
|||
|
||||
|
Re: 1938 Rear hub nut
|
||||
|---|---|---|---|---|
|
Webmaster
 
|
Most of the rear tappered axles are about 200-250 ft/lbs.
Posted on: Yesterday 22:43
|
|||
|
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
||||
|
Re: 1938 Rear hub nut
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Keep in mind that you have to get a cotter pin in there. So run up the torque until you're at least at 100 or so. Then stick the cotter pin in when you can. You don't want to go more than around 250.
Posted on: Today 1:28
|
|||
|
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry Email (Parts/service inquiries only, please. Post all questions on the forum.) service@ultramatic.info |
||||
|
||||
|
Re: 1938 Rear hub nut
|
||||
|---|---|---|---|---|
|
Home away from home
|
I always look up the size of the threaded shaft and there is a torque spec. online for that size. That nuts usually over 200 ft lbs.
Posted on: Today 3:41
|
|||
|
||||
