Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Home away from home
|
All,
I think the issue is solved. As many of you know, I went back to the starter's rebuilder and they indicated that the conditions inside the solenoid was classically caused by LOW voltage. They suspected a faulty ignition switch. My mechanic, Tom, a fellow that helped me immensely during the restoration, said the switch was fine. He doubled checked it and it was doing what it was designed to do. In essence I had (2) professionals pointing fingers in the direction of the other so to speak. What I'm impressed thoroughly about this however was that Tom telephoned the shop and spoke with their technician. He wanted to perfectly understand what their point of view was! This morning he came over to the house and rolled up his sleeves and jumped into the mechanic's pit in the garage. He poked around and then found something interesting. (As many others also recall, this past summer I had a GM L460E transmission put into the 400) What he found was that to support the transmission's new computer etc., a lead was wired into the ignition to solenoid wire that Tom had originally wired into the car when the Painless wiring harness was put in. He reasoned (and it makes sense to my simple mind) that the computer module wire to the transmission was drawing enough voltage away from the solenoid to cause our problem. A Carquest universal relay and pigtail were purchased (Numbers 56-1555 and S654) and installed. Now, using the relay, routing wire directly from the battery to the relay and then onto the solenoid, we get a solid 12 volts to the right place when it is needed. After about 15-20 starts and a 30 mile drive this afternoon, all systems seem to working perfectly again. We mounted the relay on the firewall in the area where the main portion of the harness enters the car because we had an extra hole near there on the firewall. I'll post a picture in a few.
Posted on: 2012/2/26 19:51
|
|||
|
Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Home away from home
|
Relay mounted on firewall.
Posted on: 2012/2/26 20:00
|
|||
|
Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Forum Ambassador
|
Hopefully that is the answer. Did your friend happen to measure the voltage with the computer connected? I'm curious why it took almost 5 months to start acting up.
Posted on: 2012/2/26 20:47
|
|||
Howard
|
||||
|
Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Home away from home
|
Good point; I'll ask him & cross my fingers!
Posted on: 2012/2/26 20:50
|
|||
|
Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Home away from home
|
Kevin,
Sounds like the starter problem is properly diagnosed and fixed! Craig
Posted on: 2012/2/26 22:41
|
|||
Nuke them from orbit, it's the only way to be sure! Ellen Ripley "Aliens"
Time flies like an arrow. Frui |
||||
|
Re: 5587 Starter Woes times two
|
||||
---|---|---|---|---|
Home away from home
|
Kevin, a neat bit of detective work. You obviously have a very knowledgeable mechanic. Don't forget to buy him a very nice gift for Christmas.
(o[]o)
Posted on: 2012/2/27 12:13
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|