Re: 1925 Packard Six Fuel Problem
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Your issue could be that you have a pin hole or slight dry rot crack in any of your vacuum hoses. Even if you by pass the problem your engine most likely will still run lean and therefore run hot.
Best of luck. Gar
Posted on: 2022/1/17 15:27
|
|||
|
Re: 1925 Packard Six Fuel Problem
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
No rubber hoses on a 1925 Packard except the radiator and wiper
All metal on engine
Posted on: 2022/1/18 0:07
|
|||
|
Re: 1925 Packard Six Fuel Problem
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Good Morning...I would suggest that you rig a little one gallon fuel tank, separate from the car's system and connect it to the carburetor with the little tank elevated a bit so you have flow to the carburetor. Then you will have fresh gas, with the little tank open to the atmosphere and if all is well, she will start. First oil in the cylindars to lube the walls and rings, then compression test...if it is good than I'll bet the old girl will start or try to...also clean the points, if they have grunge on them, she will not start...Ernie in Arizona
Posted on: 2022/1/18 10:27
|
|||
Caretaker of the 1949-288 Deluxe Touring Sedan
'Miss Prudence' and the 1931 Model A Ford Tudor 'Miss Princess' ![]() |
||||
|
Re: 1925 Packard Six Fuel Problem
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
If I am not mistaken there is a vacuum "tee" near the vacuum fuel pump and then it goes to the wiper unit. You can plug the 'tee' at the fitting before the wiper motor and try it. The plug needs to be a tight fit.
If you still have the problem then eliminate the end of the tee by using a small aux gas tank. Also check and ensure the vacuum engine takeoff hose is tightly secured onto the engine.
Posted on: 2022/1/18 14:52
|
|||
|