Re: Water Pumps / Cooling Systems
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The only home fabricated support block for the tube that would have to be semi-hex would be the very front support block. The other support blocks along the internal supports in the block could be any convenient shaape such as round or square/rectangular. That would make repop easier. Or maybe i viisuaalize the set up wrong.
Hoow many INTERNAL supports are there inside of the block for the tube??? About how thick are the support webs for the tube???
Posted on: 2015/2/20 12:50
|
|||
VAPOR LOCK demystified: See paragraph SEVEN of PMCC documentaion as listed in post #11 of the following thread:f
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7245 |
||||
|
Re: Water Pumps / Cooling Systems
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
Water Distro tube in a 288/327/359 block:
Posted on: 2015/2/20 13:21
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|