Packard Forum Index » Pre-War (1899-1942)

Hi all,

I wanted to wish everyone a happy holiday season and also to share this updated design for the oil filter conversion kit.

All the passages are self contained within the housing - no more fittings, hoses, etc...

I'm also going to start working on something for the vertically mounted filters.

Happy Holidays everyone!
-Crin

Attach file:

---

  1.jpg (30.54 KB)


  2.jpg (28.24 KB)


  3.jpg (36.24 KB)

This earlier filter conversion design had an integral spin on element completely enclosed. Closely matched the original.

packardinfo.com/xoops/html/modules/newbb ... c.php?topic_id=23872&post_id=232894

Yes it did. I had one of those and it was still a pain in the rear to change the oil because you still had to unbolt it, remake the gasket, split it open and get a whole lot of oil everywhere.

What I designed allows you to just unscrew the filter like on a modern car. No umbolting, no gasket making, no mess.

From the top of the engine bay you can't see the spin on filter. It looks just like the original. It's a much better design than the earlier one that houses the filter inside it. What a mess that was to change... Ugh...