Re: 1924 brake question
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I have owned several cars in the 20s with mechanical brakes . check to make shur the axle is not moving front and back loose spring pin or ubolts. also I have had shoes come loose and jam inside the drum.if that is not it take apart all the linkage and clean it at every joint.My Packard had the part that goes through the backing plate sticking.
Posted on: 2014/5/22 3:27
|
|||
|
Re: 1924 brake question
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Seth, I do not have that problem with my 1929 633 which has a similar braking system however I have spoken with owners of other similar models with the same problem you describe. I also have a friend with a Lincoln with the same braking setup as our Packards, that car also locks up a front wheel on full steering lock.
Why some cars have the problem and others don't is a mystery , all I can think is that the brake adjustment needs to be backed off a little so that the brakes do not bind on full lock. However this solution does not work on my mates Lincoln, the brakes need to be backed off so much they do not work at all. Hopefully others will come in on this problem. 29tons suggestions are all worth checking but the problem can occur on cars with none of those problems.
Posted on: 2014/5/22 17:12
|
|||
|
Re: 1924 brake question
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
I think my problem is a result of the brakes not fully releasing. The cable pulls on a lever mounted above the axle. This creates rotation of a linkage that uses a universal coupling to then enter the brake housing. If I help that linkage back to fully relaxed position, the wheel moves freely. So this raises two questions...
1.) I thought I might try greasing the fittings associated with this linkage. What type of grease gun fitting do I need to attach to the pin type grease fitting? See picture...sorry a bit blurry... 2.) If the linkage still doesn't return to the desired position, is it possible a weak or broken brake spring is to blame for lack of energy to return the mechanism to the brake release stop? Thanks for any help.
Posted on: 2014/9/30 11:47
|
|||
|
Re: 1924 brake question
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
By all means, anything with a grease fitting (and many things w/o them) should be lubricated regularly - can't say that will solve your problem but it's a start as unwanted friction anywhere in a mechanical brake system is bound to give problems. Most all cars of the late 1920 and earlier had that type of early cross-pin Alemite fitting and the adapter is still commonly available, thru MSC in Harrisburg and probably others as well. You can either fasten the end of your grease gun to the adapter, or fit the end of the adapter with a modern Zerk fitting.
Picture of the adapter attached. Attach file: ![]() ![]()
Posted on: 2014/9/30 12:30
|
|||
|
Re: 1924 brake question
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
Thanks for confirming this should work. I came across it, but not much supporting info for me to know if it what I need.
The order has been placed!
Posted on: 2014/9/30 17:02
|
|||
|