Packard Forum Index » Pre-War (1899-1942)

Hoping someone can help me... I'm looking for a source or at least the dimensions for the tiny screws that hold the raw wires in place at the connector where the headlight harness meets up with the main harness.

See picture below. The screw goes into the hole in the middle.

If someone could post a picture of one, that would be great too.

Attach file:

---

  (153.68 KB)

I think you are asking about the one inside the headlight. If memory serves me correctly it is a 8-32 slotted set screw. When I get a chance later this week when I have the car backed up out of its parking spot, I'll take a look.

MY BAD!!! I thought this connector went to the headlight when in fact it goes to the HORN!

Note to self: Make sure I know exactly what I'm talking about BEFORE asking folks for help!

I'll make a new post with the correct title.