Packard Forum Index » Pre-War (1899-1942)

I am brand new to the Packard community, therefore needing some advise.
What is the price range to buy a good running and well rebuilt 1941 Packard 6 cylinder Engine with about 20 run hours on it? Thank you

The partially rebuilt 1940 110 engine here is $1,250 with some assembly required but I expect that a fully rebuilt one would cost several times that and possibly even more to have yours done. This one here is so cheap because it was done decades ago.

A Packard Six rebuild would be north of 4K, easily; I've priced one twice in the past three years. Don's engine is a very good deal. I'm refreshing an October '46 built 245, an unfinished project of the prior owner of my 37 115c, for the price of paint and a gasket set, plus a $500 parts engine. That engine will go in my '40 110.

If the engine is as you state and you can get it for less than a couple grand, buy it and take some Advil because your face will hurt from smiling so much at the money you saved.

Tsherry, you should have saved yourself some money and at the same time had the proper 1940 110 engine by buying mine! It’s in Central Oregon not far from you and I even have the proper green paint for it!.

Probably right....