Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Probably a fuel problem since you have just done an ignition tune-up. It sounds to me like it is starving for fuel. Plugged up filter? Check the filter first, if you have one. If not, remove the bottom bowl from the fuel pump and see what is there. May have stirred up some dirt with the last fuel fill-up and that is what is causing the problem.
One more thing, is the gas cap vented? (o[]o)
Posted on: 2012/9/10 10:18
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
thanks for the advice. i will try the fuel pump......
i have an aftermarket filter that i recently replaced. it was on the car when i bought it. it was instaled down low near the pump. i notice yesterday while reading on this site that an original looking filter was located up near the carb..... thanks for your help
Posted on: 2012/9/10 13:16
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
the gas cap...? i don't know, but i will check and research.
Posted on: 2012/9/10 13:24
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Those original ceramic filters can get clogged or if the bowl has dried with gas in it, get varnished up. Symptoms are a lot like you describe.
New elements are available but not many places stock the small size Packard used. They were used on some farm equipment also so a farm supply store might have new if you have any stores like that over there. The old elements can be cleaned with a soak in acetone or carb cleaner and then compressed air blown thru backwards to force particles out. If you do decide to clean it, make sure to have a new gasket available. Max and most likely the other vendors have them if needed if you can't find a store selling elements. The old gasket will probably leak if you try and reuse it. Tightening to try and stop a leak will most likely break the glass.
Posted on: 2012/9/10 13:31
|
|||
Howard
|
||||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
thanks HH56
the aftermarket filter on my car is the disposable type . someday i would like to get a more period correct. and when i check the fuel pump i will have a new gasket. as always thanks for you help
Posted on: 2012/9/10 13:41
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I may as well just get a new in line fuel filter at the parts store eeven though i replaced it maybe a year ago. i will add this to my to do list.
Posted on: 2012/9/10 13:43
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Dear Tim:
Let's look at the symptom: Everything is fine until the car is fully warmed up. Buy a KD spark tester from NAPA and take the car out on the road. When it acts up pull over and check the spark. You should have at least 20Kv. You may need to make a dark room or pull under a bridge for the test. Then pull a plug. If it is black it's ignition, if it's white it's fuel. Hope this helps.
Posted on: 2012/9/10 16:28
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Thanks Mr Cole, i will take your advice. I just read about this in another thread . i will check napa . i hope they stock it here on the island. thanks for your help.
Posted on: 2012/9/10 17:08
|
|||
|
Re: '52 200, ultramantic, runs rough at about 50mph or more
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Sometimes, things like this are like finding a needle in the proverbial haystack. To avoid frustration and that sense of overwhelm, what I do first is check the obvious, and in your case, that would be double checking the tune up (or other adjustments) you might have made...basically a re- do of the work. Start with the timing, if you installed points, that should have been re set, and make sure you put some synthetic grease on the distributor shaft. Tighten the wires, make sure the vacuum lines are in, etc.
Kanter makes a replacement glass bowl fuel filter with a paper element, get yourself one ($35), It's not worth the hassle to clean out the original and fit a new gasket, besides the paper element of a modern one is superior to the 60 year old porous one... just get to NAPA and have a couple of fittings available, the OEM ones are bronze so they'll likely split when you take them off. Lastly, I'm not sure about diesel as an additive here..I know...'Reduces detonation and therefore knock', but it can't contribute to smoothness as diesel burns far dirtier (and therefore likely to plug) the spark plugs. Besides, the CR on your car isn't so high that you're in danger by using today's "Premium". Lastly, check the trans fluid level...it's a long shot, but if she's low, you'd notice that as 'roughness' at higher speeds.
Posted on: 2012/9/11 12:20
|
|||
1954 black Patrician, unrestored, mostly original, minty!!
|
||||
|