Re: trouble bleeding brakes
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Make sure to always put some kind of thread sealant on your bleeder screws, that will help immensely. I used Permatex/ 65 to 300 degree thread sealant.
Posted on: 2012/6/22 20:20
|
|||
Garrett
1952 200 Deluxe Touring Sedan " If you don't go when you want to go, when you do go, you'll find you've gone"- Burt Munro |
||||
|
Re: trouble bleeding brakes
|
||||
---|---|---|---|---|
Quite a regular
![]() ![]() ![]() |
Thank you for the reply.
Is there a chance I will be able to pump fluid after putting sealant in the threads, if my pedal is going to the floor now without pumping fluid? If not, what should I do?
Posted on: 2012/6/22 20:35
|
|||
|
Re: trouble bleeding brakes
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Make sure the fluid in your master cylinder is topped off. I'm not too familiar with the manual setups, maybe someone else can give you some advice.
-Garrett
Posted on: 2012/6/22 20:44
|
|||
Garrett
1952 200 Deluxe Touring Sedan " If you don't go when you want to go, when you do go, you'll find you've gone"- Burt Munro |
||||
|
Re: trouble bleeding brakes
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
A thread sealant isn't required and in any case it's risky in that it presents the possibility of introducing a foreign chemical substance into the brake fluid.
You can't reintroduce air back into the system if you close off the bleeder screw before allowing the brake pedal to return. So, standard old brake bleeder method - no special tools required - just a helper. Pump the pedal a few times and hold it against the toe board while your helper opens the bleeder, and closes it again before you release the brake pedal. Repeat until you get a solid uninterrupted stream of brake fluid. Do the wheel furthest from the MC first. Keep the MC adequately filled with fluid and check it often.
Posted on: 2012/6/22 20:46
|
|||
|
Re: trouble bleeding brakes
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
If you have the original bleed screws, it would be best to replace them with new bleed screws, but keep the old screws. After that you can stick a hose on to the new bleed screws and put the hose down into a jar with some brake fluid all ready in it. It is best to have two people for this job. One person steps on the brake and holds it down, while the other person opens and closes the bleed screw with every press of the pedal. After you get the feel back in the brake pedal you should be ready for a test drive. Just make sure to keep an eye on the brake fluid and use slow strokes on the pedal.
Posted on: 2012/6/24 21:52
|
|||
|