Re: Rotating Air Cleaner.....'55 Patrician
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Don't remember hearing of that being an issue and don't think there is a keyway. Will be interesting to know if someone else has experienced it.
Without tightening the nut more, wonder if a possible solution (if there is enough of a lip on one piece or the other) would be to add an O ring around the seat area and possibly a rubber washer under the nut to provide a bit of friction. If that would work, McMaster-Carr has O rings in various materials, thickness and configurations in large diameters around that size
Posted on: 2013/6/14 18:39
|
|||
Howard
|
||||
|
Re: Rotating Air Cleaner.....'55 Patrician
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The 55's are supposed to have a rubber seal between the snorkel portion and the filter pot. You could fake this nicely by finding the smallest black rubber vacuum tubing you can lay your hands on and gluing it to the filter pot around the edge where the snorkel fits.
Posted on: 2013/6/14 20:17
|
|||
|
Re: Rotating Air Cleaner.....'55 Patrician
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
There is a gasket fit from top to bottom piece and bottom piece has indent above fuel filter. I have a small plastic then metal washer to tighten the wing nut against.
Posted on: 2013/6/14 21:28
|
|||
|
Re: Rotating Air Cleaner.....'55 Patrician
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
Thanks for the helpful information. Didn't realize there was supposed to be a rubber gasket..... Just a little searching....and found this online listing for one.....
which I bought....will post more when it arrives and if it cures the problem of the rotating top piece..... http://www.ebay.com/itm/NOS-1955-Packard-Air-Cleaner-Seal-NEW-/150839547374?pt=LH_DefaultDomain_100&hash=item231ebcd5ee&vxp=mtr
Posted on: 2013/6/15 9:00
|
|||
De Mortuis Nil Nisi Bonum...Speak Only Good Of The Dead.....
|
||||
|