(38.05 KB)
|
Re: 1951 24th series and on grille teeth factory cutout to fit grille?
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
I did not think Packard would have bothered with the extra work and just welded them in instead
Welded steel to die cast pot metal? Now that would be quite the trick.
Posted on: 2015/2/2 9:56
|
|||
|
||||
|
Re: 1951 24th series and on grille teeth factory cutout to fit grille?
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Bolted into place. See group number 30.874024. The outer teeth are different - the inner 6 teeth are the same.
Posted on: 2015/2/2 10:26
|
|||
|
||||
|
Re: 1951 24th series and on grille teeth factory cutout to fit grille?
|
||||
|---|---|---|---|---|
|
Quite a regular
 
|
Thanks Ec Anthony, do you know of any pictures online that show the actual method for attachment? Tried the find engine here and google with no luck so far. Thanks for the response though.
Gene.
Posted on: 2015/2/2 10:38
|
|||
|
||||
|
Re: 1951 24th series and on grille teeth factory cutout to fit grille?
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
...do you know of any pictures online that show the actual method for attachment
No picture, but when in doubt check the parts book, it shows sixteen 1/4-14 screws and speednuts.
Posted on: 2015/2/2 12:33
|
|||
|
||||
|
Re: 1951 24th series and on grille teeth factory cutout to fit grille?
|
||||
|---|---|---|---|---|
|
Quite a regular
|
Will do, thanks Owen.
Posted on: 2015/2/2 12:35
|
|||
|
||||
