|
Need good foundry recommendation
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
I probably need to have a gas cap cast for my 740 and am looking for a good foundry to do a one off sand casting. Any suggestions for a reliable outfit? Anyone had experience with Leerock Foundry of Ontario California?castmetalparts.com/Home_Page.php
Posted on: 2018/4/18 18:37
|
|||
|
Rob
1930 Custom 8 Club Sedan |
||||
|
||||
|
Re: Need good foundry recommendation
|
||||
|---|---|---|---|---|
|
Home away from home
|
Did you contact American Arrow in suburban Detroit?
Don and his son Dan own the place and I would not be surprised if they had a newly cast one laying around as Don owns two 740's - one a phaeton and the other a club sedan. Call (248) 435-6115 in the eastern time zone. Most of the castings he does are in stainless steel, then chrome plated. americanarrowcorp.com/ Hope you get what you need.
Posted on: 2018/4/18 19:44
|
|||
|
||||
|
Re: Need good foundry recommendation
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
You might also look into Firebird Bronze in Oregon. Joe had them cast some some prewar AC vents in bronze using some wax molds I made. Joe said the vents turned out decent. They are willing to work in small quantities although I believe the vent minimum was a quantity of two. They also offer sand casting but I didn't check to see if they work with metals other than bronze.firebirdbronze.com
Posted on: 2018/4/18 20:02
|
|||
|
Howard
|
||||
|
||||
