tbirdman	Water jacket installation for 1932 903	#1
Home away from home Joined: 2008/6/29 22:25 Last Login : 2023/6/13 17:04 Group: Registered Users Posts: 367	I've used Teflon thread sealant when installing the 44 bolts holding the water jacket on. I've had a few minor leaks. I'm re-installing the water jacket with a new gasket. Any recommendation to help prevent the minor water leaks from the bolts? Posted on: 2017/12/21 7:16

Owen_Dyneto	Re: Water jacket installation for 1932 903	#2
Forum Ambassador Joined: 2007/3/14 18:01 Last Login : 1/6 17:16 From New Jersey Group: Registered Users Forum Ambassadors Posts: 16708	I used gasket shellac, no problems. Posted on: 2017/12/21 9:13

Packardbarry	Re: Water jacket installation for 1932 903	#3
Home away from home Joined: 2009/9/14 17:46 Last Login : 1/7 18:31 From Salt Lake City, UT Group: Registered Users Posts: 481	Originally under the bolt hd was a soft copper washer. As far as i know these r not available. U can find a copper washer but there hard. Ive been using these sealant washers 93783A029 from McMaster Carr (same OD as orig) www.mcmaster.com Posted on: 2017/12/21 10:18

Owen_Dyneto	Re: Water jacket installation for 1932 903	#4
Forum Ambassador Joined: 2007/3/14 18:01 Last Login : 1/6 17:16 From New Jersey Group: Registered Users Forum Ambassadors Posts: 16708	I suppose you could anneal the commercial hard copper washers? Posted on: 2017/12/21 10:25

tbirdman	Re: Water jacket installation for 1932 903	#5
Home away from home Joined: 2008/6/29 22:25 Last Login : 2023/6/13 17:04 Group: Registered Users Posts: 367	Owen-Do you use the gasket shellac on the bolt threads? The washers from McMaster 93783A029 seem like a good solution. Posted on: 2017/12/21 14:51

Owen_Dyneto	Re: Water jacket installation for 1932 903	#6
Forum Ambassador Joined: 2007/3/14 18:01 Last Login : 1/6 17:16 From New Jersey Group: Registered Users Forum Ambassadors Posts: 16708	Yes, on the threads. Posted on: 2017/12/21 16:52