Re: Wipers Working! but catching pillar
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Assuming the cables and mechanisms are all undamaged there is not a lot of adjustment possible. You might have a look at this bulletin issued for the 22nd series as it gives a procedure for making sure the cables are tensioned correctly.. It also gives some position guidelines and touches on how to reposition the blades on the mounting splines if the wiper blades are traveling over the weatherstrip.https://www.packardinfo.com/xoops/html/downloads/STB/47T-33.pdf
Posted on: 2019/8/30 16:35
|
|||
Howard
|
||||
|
Re: Wipers Working! but catching pillar
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
The adjustment is via the positioning of the arm on the hub.
Posted on: 2019/8/30 17:27
|
|||
|
Re: Wipers Working! but catching pillar
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I'll take a look at the wires and maybe see if I can adjust the positioning on the hub for the blade arms. If there's no other adjustment, maybe someone tried running them under snow or something and they shifted on their mount. I suppose I could also bend things or try trimming the wiper blade metal housing as a last resort.
Posted on: 2019/8/30 18:41
|
|||
|
Re: Wipers Working! but catching pillar
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The wipers are going to rotate through a definite arc determined by the wiper motor and the the cable drives.
The question then is how far down the blades come as they approach the cowl. On your car they should come within 1/2 inch or so of the molding while running and should park tight and parallel to the molding. Pull your arms off, park the wipers then press the arms back on to have them touch the rubber at the cowl. If you get that right the A pillar should be OK though they always did run close.
Posted on: 2019/8/31 6:12
|
|||
|