Packard Forum Index » Pre-War (1899-1942)

I sent my water pump off to be rebuilt, the Main casting is too far gone. According to the Parts Manual my pump is one year only, and only for the large 8 in the 640/645. It mounts on the front of the engine, not down low on the side.

I have all the usual's looks and scouring. Any suggestions?

I have a nearly complete 640 Club sedan parts car - but no pump. What do you need? Lets get these cars back on the road.

I have a 645 with that front mounted water pump. I don't have a spare and fortunately mine wasn't too beat up. That is a fairly simple part and I'm guessing if worse comes to worse, you could have the original re-cast and machined. I know my machinist cleaned up the bore on mine to make sure the shaft lined up straight, so it can be done...I have spares of the roller bearings and the impeller head I would be willing to sell for cheap if you are interested.

I have a 645 with that front mounted water pump. I don't have a spare and fortunately mine wasn't too beat up. That is a fairly simple part and I'm guessing if worse comes to worse, you could have the original re-cast and machined. I know my machinist cleaned up the bore on mine to make sure the shaft lined up straight, so it can be done...I have spares of the roller bearings and the impeller head I would be willing to sell for cheap if you are interested.

PM sent

I'm interested in your spare parts.

Thanks,
Greg

I have a spare front mounted 640 water pump. It needs a new shaft, but otherwise is complete and in good condition. Contact me at hiway9999@hotmail.com

Jim Wayman

Awesome! Thanks for considering selling your spare. I have sent you an email mail.

Greg