Re: Carter & Rochester Carburetor Inlet fitting
|
||||
---|---|---|---|---|
Home away from home
|
Right
1/8 pipe at carb. And at fuel pump The picture is correct
Posted on: Yesterday 21:22
|
|||
Riki
|
||||
|
Re: Carter & Rochester Carburetor Inlet fitting
|
||||
---|---|---|---|---|
Home away from home
|
Thank you, Riki. The one photo shows a Rochester which appears to have 5/16 or maybe 1/4 flare so how does it connect to the filter?
Posted on: Yesterday 21:27
|
|||
|
Re: Carter & Rochester Carburetor Inlet fitting
|
||||
---|---|---|---|---|
Home away from home
|
Yeah the fuel line is 5/16 flare. The elbow is not though. I need to dig through my spares but won't be home until late tomorrow.
Posted on: Yesterday 21:45
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: Carter & Rochester Carburetor Inlet fitting
|
||||
---|---|---|---|---|
Home away from home
|
There’s no elbow to the filter from the carburetor as far as I can tell. It should just go straight out from the carburetor to the filter, then there is a 90 degree on the filter’s inlet from the pump.
Posted on: Yesterday 22:23
|
|||
|
Re: Carter & Rochester Carburetor Inlet fitting
|
||||
---|---|---|---|---|
Home away from home
|
Correct.
Posted on: Today 6:18
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|