Packard Forum Index » V-8 (1955-56)

Topic: Steering gear adjustment

Bottom

Previous Topic

Next Topic Register To Post

(1) 2 »

humanpotatohybrid

Steering gear adjustment

Home away from home

I'm trying to set my steering to spec per the book and am pretty confused on some things. The shims I get, to set the play on the ends, but I don't understand the adjustment to make to get it correct on the middle

The other thing is, my engine is out, would it be easier to remove the assembly and work on it on the bench? I didn't buy a replacement seal but I can get one.

Posted on: 10/19 20:03

TxGoat

Re: Steering gear adjustment

Home away from home

Make the pitman shaft adjustment with the steering box in the straight ahead position. Some play is normal when the steering box is near the left or right stops. There should be no play with it on center. The worm shaft adjustment can be done at any position, I think.

If you set the pitman shaft adjustment with the steering box OFF center, it will bind when turned left or right.

Posted on: 10/19 20:42

humanpotatohybrid

Re: Steering gear adjustment

Home away from home

Yes but how do I make thar adjustment? There is a bolt next to the filler plug on the housing that I can loosen, but then it seems like it won't stay in place.

Posted on: 10/19 21:17

BigKev

Re: Steering gear adjustment

Webmaster

They should be a large star shaped washer that locks that in place.

Posted on: 10/19 21:21

-BigKev

1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog

1937 Packard 115-C Convertible Coupe -> Registry | Project Blog

HotRodKid56

Re: Steering gear adjustment

Just popping in

I Think This would help to you it has pretty same steering box too

Posted on: Today 8:40

humanpotatohybrid

Re: Steering gear adjustment

Home away from home

Thanks Kev, the washer is there, but it doesn't seem to do much to hold it in place.

Anyone remember how to remove it? Obviously it's bolted to the frame rail but what do I do about the steering column and the output shaft of the gearbox?

Posted on: Today 8:52

Packard Don

Re: Steering gear adjustment

Home away from home

The video is blocked here in the U.S. due to, as the message says, copyright grounds.

Posted on: Today 12:02

All generalities are false.

Don Pierson
Packard / IMPERIAL page
CA DMV Licensed Vehicle VIN Verification

1951 Henney-Packard 3-Door Long Wheelbase Air Force Ambulance
1954 Packard Patrician
1954 Packard Patrician Parts Car
1956 Clipper Custom Sedan

BigKev

Re: Steering gear adjustment

Webmaster

If I remember right that odd star washer can only lay in one of four positions because the one sides engages a stop/pin/bump on the steering box.

Perhaps that is sheared off?

Posted on: Today 12:31

-BigKev

1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog

1937 Packard 115-C Convertible Coupe -> Registry | Project Blog

humanpotatohybrid

Re: Steering gear adjustment

Home away from home

I think next weekend I will just get it out of the car and go through it. I hate to do that since it's so dirty on the outside and I'll need to clean it, but it seems that's what's needed to adjust it properly. Also a change of gear oil would not hurt I think...

Posted on: Today 12:47