Packard Forum Index » V-8 (1955-56)

Mine has slop

The only thing that adjusts height is that shoulder bolt . 9/16 nut.

You have to hold window up way up

Pull that bolt up. Loose

Then tighten nut.

Make sure those upper stops are loose.

The original motors are slow.

The left side motor seemed to be sluggish when compared to the right side. I've have the motor plus linkage out of the car. I need to remove the gear in the motor's housing, but it doesn't want to budge. I'm assuming that the sprocket gear/shaft is pushed into the gear inside the the worm gear. What's the secret?

Drive gear? (Shaft).

Tap it out of worm wheel.

I just ran across boat load of motor parts.
If you need a picture let me know

By gear/shaft I'm referring to the part on the left side of the housing and assume by worm gear you mean the gear on the right side of the housing. Not sure what you mean by tap it out. I have tried to remove the gear/shaft by pulling it towards the left to no avail.

Attach file:

---

  window_motor1.jpg (444.66 KB)


  window_motor.jpg (364.55 KB)

Tap here

But get the gear back inside

Attach file:

---

  20241220_131519.jpg (799.65 KB)

Riki - Thanks that's where I had been tapping before posting, but it was stubborn. I posted out of caution, With your help and a little WD40 it's out.