Packard Forum Index » Pre-War (1899-1942)

We were successful in getting our 39 V12 back to running condition last week.
We reconditioned the fuel system by rebuilding the Stromberg Carb, new fuel lines and cleaned and sealed the tank.
The old beauty runs smoothly now but the trunk will not open.
Before we start removing the rear seat to hopefully gain access to the lock, I’m looking for any suggestions and warnings.

Prior to the today, I was able to lock and unlock the truck handle and we were able to open and close the trunk easily.
Now the handle just spins and no difference if the lock is engaged or not.

Thanks in advance,
Bill
NPM Warren, Ohio

Attach file:

---

  IMG_0433.png (5,744.09 KB)

Can you reach where the latch bolts to the floor pan underneath?

I'll check on Friday.
We just had the gas tank out for cleaning and sealing. Hope we don't have to pull the tank again.


Thanks
Bill

The junior models of 1939 latched with sliders moved by the handle to the sides so I am curious if the senior models are the same or do indeed have a central latch.

Ok, I've got some answers but of course more questions.

The underside of the 39 does not show any bolts or mounting mechanism.





After removing the seat, there are 4 bolts exposed.





After removing those 4 bolts, the seat back is still held in place securely somewhere on the top section near the flip down armrest.
We tried pulling up, down and to the front on the seat back and it won't budge.
We look at our 1940 110 series car and saw how that seat back was held in place. Doesn't seem to be similar.
Can't see how to properly remove the armrest fabric if in fact there are more fasteners there. Using a mirror, we could see the pointed end of bolts or screws behind the seat, up high. But would need trunk access to get to them.





Any ideas?

Thanks

Bill
NPM Warren, Ohio