Packard Forum Index » Project Blogs

It seems to me that you should complete the Jaguar engine. I bet most of us who helped the first time would help again. I know I will. It is just such a cool project. How about it everyone? Kev is special. Ernie in Arizona

Quote:

Kev - if it does come down to it and you needed to switch back to stock, there is a '37 115-C engine for sale near me. Complete with two transmissions. If you needed it I could easily pick it up and have it shipped. Yes it wouldn't be the Jackard anymore, but once you go through this engine I expect it would work great. Good news is it's only $350.
https://kpr.craigslist.org/pts/d/prosser-packard-cyl-engine-complete-1937/7851085378.html

Russell finished stripping down the Jackard's original block and it went into the wash cabinet for three hours today.

Russell doesn't think this motor has ever been apart. Still is standard bore, but with taper. So even if we were not going to use the .30 over pistons, it would probably still have had to go to at least .20 over to remove the taper.

He said at first glance everything looks good with it. It will get magnifluxed to be sure.

He said the deck looks really good, so it will just get "kissed" to clean it up.

He did a cursory inspection on the head (valves, springs, tappets, surface, etc) and everything looks new/rebuilt and no rust.

In other news...

Finished up most of the wiring, and also realized I had forgotten to install the wiper towers and linkage. Which would have been infinitely easier before I mounted the headlight switch and all the wiring.




Just in time, as we had thunderstorms coming in this evening! 😅

Also I got Nicole's bluetooth entertainment system re-mounted. These are just inexpensive, weather proof speaker pods and a small bluetooth/amp module. It's all mounted complete behind the dash and not visible. We ran this last season and it sounds pretty good even while driving with top down. All controlled/streamed from her phone.




Once that was done, I got the glove box door mounted and the liner installed. Also made and ran a harness for a future clock.