Re: headaches and miseries..what are these parts for
|
||||
---|---|---|---|---|
Home away from home
|
After helping my friend with his father's 1936 Dietrich 120B Convertible Sedan, I recognized these two wood pieces immediately. They seem similar, if not identical, to the seat track spacers found under the front seat of a 120B. There should be one countersunk screw, and two more holes a bit back on both pieces. The wood was painted a flat black.
Once his seat leather was replaced, it only took us a few minutes to re-fit the wood spacers into the existing floor holes. I'd imagine that a rather tall owner might elect to have the dealer remove them for more clearance under the steering wheel. I'm six feet tall, and the seat height with spacers installed, seems just right. Once again, a 1936 car like my friend's, would not have any Phillips head screws unless it was one of those new Cadillacs where they debuted. A later car, like the one in question, might or might not have them instead of the slotted variety.
Posted on: 2015/9/20 11:16
|
|||
|
Re: headaches and miseries..what are these parts for
|
||||
---|---|---|---|---|
Home away from home
|
Again, Thanks all for the input. These are of oak lumber, painted black and counter sunk for 5/16". I am looking thru plastic bags of fastenings to see if there are four machine screws that size. There are other parts of the front seat assembly that are also oak and painted black so pretty sure these are from that car. (most of the other cars these guys were working on were late 50's to 60's classic muscle cars and early Broncos.
Desk Drver....sent a few more pics with a 5/16 joint peg as reference to the holes. No screws are in the blocks of wood.
Posted on: 2015/9/20 14:55
|
|||
Where principles are involved, be deaf to expediency. (Matthew Fontaine Maury 18th century oceanographer)
|
||||
|
Re: headaches and miseries..what are these parts for
|
||||
---|---|---|---|---|
Home away from home
|
Desk Driver...
I went back to OP and looked at the wood blocks again. Dang if there doesn't look like there is a Phillips head dry wall screw in the hole. I took the block and twisted and turned it in different light and different angles and I can see the ghost Phillips head. It is a check in the grain and a dark streak of black paint that gives the illusion. You weren't see'n things but then again....the hole is empty though!
Posted on: 2015/9/20 15:13
|
|||
Where principles are involved, be deaf to expediency. (Matthew Fontaine Maury 18th century oceanographer)
|
||||
|
Re: headaches and miseries..what are these parts for
|
||||
---|---|---|---|---|
Home away from home
|
OK....Mystery solved on wooden blocks. They are the transition blocks that fit at the jump seat pivot point brackets to protect carpet from sharp edges of floor pan. Thanks for all the input and suggestions. who knows, this might be my new career making these for replacements ;)
Posted on: 2015/10/30 14:54
|
|||
Where principles are involved, be deaf to expediency. (Matthew Fontaine Maury 18th century oceanographer)
|
||||
|