|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Don
Would you consider dunking it in Evapo-rust and report back if the surface finish of the cam is acceptable? Dp
Posted on: 2023/11/4 13:23
|
|||
|
||||
|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
|
If it were just surface rust it wouldn't be a problem but it is deeply pitted too so should be replaced. The cam should be shiny and smooth!
Posted on: 2023/11/4 14:36
|
|||
|
||||
|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
|
I’m thinking the rubbing block may not mind a few pits along the way, especially when the block is off of the cam.
Posted on: 2023/11/4 17:24
|
|||
|
||||
|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
|
I would just blast the rust off with a steel wheel and check the operation. Pits aren't ideal but to me it looks like there is plenty of bearing surface left if it were just cleaned.
Posted on: 2023/11/4 19:36
|
|||
|
'55 400. Needs aesthetic parts put back on, and electrical system sorted.
'55 Clipper Deluxe. Engine is stuck-ish. |
||||
|
||||
|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
|
HHP
I would think Evapo-Rust would remove the 'red rust' and then allow a much better visual inspection. If what remains is a bunch of pits located where the rubbing block doesn't touch the cam then that's OK DP
Posted on: 2023/11/4 19:53
|
|||
|
||||
|
Re: Need Autolite Distributor Cam
|
||||
|---|---|---|---|---|
|
Home away from home
|
I ended up going the easy way by handing it over to my brother to take to his shop next door where he worked wonders with it! He’s really good that that sort of thing. What looks like a pit in the photo is actually a discoloration so it will be fine.
Attach file:  6611FA61-2C6A-40A4-8D8F-1CFF954F41E7.jpeg (363.58 KB)
Posted on: 2023/11/4 20:17
|
|||
|
||||
