|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
Packard specs say 30 degrees. I would wonder where Max got the 60 degree number as that seems very contrary to what Packard published in all the service material during the years of use for the 282 engines. Were the seats changed?
Here is the published 1941 282 valve info from Vol 17 #14 service counselor Attach file:  282A.jpg (320.16 KB) 282B.jpg (185.00 KB)
Posted on: 2021/4/21 17:17
|
|||
|
Howard
|
||||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
I've never seen any valves using a 60 degree seat....
Posted on: 2021/4/21 18:54
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Home away from home
|
Absolutely do not cut extra metal off the valve seat. There is no easy getting that back. 30 degrees it is for certain. Please post a picture of what you are seeing.
Posted on: 2021/4/22 12:00
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Just popping in
 
|
Big thanks for stopping me everybody. They are 30 degrees. My next question is, the exhaust valves all seat in the middle of the valve like they are suppose to, but all the intakes seat high at the top. They do sit on the entire seat for a good seal I do believe. Do the intakes normally ride high? I do not want to do a 2 or 3 angle cut to achieve this if I don't have to. Any help is greatly appreciated.
Posted on: 2021/4/26 13:49
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
Before considering what to do about it if anything, how wide is the seating surface? If it's excessively wide, you're going to want to narrow it so then just bring it down from the top.
Posted on: 2021/4/26 15:23
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Home away from home
|
The pattern on the intakes typically rides high. It won't make a problem in that the intakes get only fractionally as hot as the exhausts.
Posted on: 2021/4/26 19:32
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Just popping in
|
There is not much seat here compared to newer motors. This is what I am looking at. How do I bring it down from the top?
Attach file: int an exh valve an seat.jpg (221.20 KB) intake valve.jpg (205.74 KB)
Posted on: 2021/5/1 9:50
|
|||
|
||||
|
Re: 1941 120 282 valves seat angle not right
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
Typical desired seat width is about 3/32". If you need to reduce it and move it down from the top, just use a suitably angled stone or cutter.
Posted on: 2021/5/1 13:11
|
|||
|
||||
