Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Home away from home
|
Hi 41 Touring
An old-time mechanic here swore by four quarts of oil and a quart of automatic transmission fluid to quiet noisy lifters. It's a great lubricant and detergent enough to clear small passages. I've used it in tired engines over the years with success. Others will have good advice to follow too. Steve
Posted on: 2017/5/16 8:08
|
|||
.....epigram time.....
Proud 1953 Clipper Deluxe owner. Thinking about my next Packard, want a Clipper Deluxe Eight, manual shift with overdrive. |
||||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Home away from home
|
Rislone will clean out an engine? John
Posted on: 2017/5/16 8:13
|
|||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Forum Ambassador
|
Years back the two most popular snake oils for noise lifters were Alemite CD-2 and Shaler's Rislone. Whether either ever actually performed as promised is open to debate.
Posted on: 2017/5/16 9:22
|
|||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Forum Ambassador
|
I am curious why only when hot. I think I would check the oil pressure with a mechanical gauge in place of the sender or maybe permanently add a hidden mechanical gauge setup in parallel as a backup. There are ports on the main gallery on passenger side of engine where this could be done and the sensing tube run somewhere so the gauge is tucked out of sight.
The oil pressure is spec'd at around 40psi at normal driving speed but is considerably lower at idle. Maybe something is worn or the oil is the wrong weight and when hot, is thinning so much that the noisy lifter is a symptom of another problem coming to light.
Posted on: 2017/5/16 9:49
|
|||
Howard
|
||||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Webmaster
|
Yes, so curious on oil pressure. Bypass oil filter setup? Restrictor could be missing. If pressure is low, then you could shim the oil pressure relief spring in the pump.
Posted on: 2017/5/16 9:53
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Home away from home
|
FI believe all '52's came equipped with a bypass filter. If the restrictor were missing it would show lifter problems well before an hour's running on the road. From my experience it seems like the one lifter is leaking a bit and when hot and the oil is thin it ticks.
Change the oil and filter, try a multi-vis oil od a heavier weight, 10W- 40?? If that doesn't fix it replace the bad lifter
Posted on: 2017/5/16 11:49
|
|||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Webmaster
|
Fred, oil filters were still an option then. Also, you never know what changes a previous owner made. My '54 actually has a prewar oil filter on it and was not plumbed in by-pass configuration when I got it.
Here is a snippet from the Accessories section of the Parts List.
Posted on: 2017/5/16 12:30
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Webmaster
|
Also, with the Southern Calif heat (I noticed your location says Irvine, CA, I lived in Riverside) I ran Shell Rotella or Chevron Delo 15-40 engine oil. When I ran thinner oil, I got a lot of blow by on hot days and a flickering oil pressure light after long freeway runs.
After using 15-40, I never had the problem again. Just my
Posted on: 2017/5/16 12:35
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Hydralic lifter noise
|
||||
---|---|---|---|---|
Home away from home
|
"Rislone" is the name I was looking for. I have heard the ATF solution before but never tried it.
I do have the by-pass filter. I think you guys are right, I should run a guage at least until I get this sorted out. I can run one temporarily from the trouble light indicator. BTW BigKev, I now live in Cambria, on Ca. central coast, where neither cars or drivers ever overheat. So, it takes a long drive to truely get the car to its max heat. I'll try a guage and let you know what I find. Thank you all for the advice.
Posted on: 2017/5/16 12:53
|
|||
1941 Touring Sedan
1952 250 Convertible 1932 902 Rumble seat Coupe Who is John Galt? |
||||
|