Bottom
Previous Topic
Next Topic
Register To PostTopic is Locked
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Home away from home
|
Howdy & G'day,
Henry and Warren, you set me a task to find out about those timing sprockets. I worked out that I bought them on eBay in 2006 and did it using a computer that had been superseded soon after. However, you're in luck as I was able to resuscitate the old computer and after a long wait, found the item we wanted. I bought the gears from Mark Sarine, Mad Dog Racing and Fast Engine Parts, 3901 SW 47th Avenue (#413), Ft Lauderdale, Florida 33314. The telephone # given then was (954) 7929800 and his internet (email?) address was dwpartsguy@erwparts.com. A bit of electronic sleuthing might track him down if these contact details are out of date. Good luck, John
Posted on: 2012/4/4 0:40
|
|||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
Thanks Wayne and John for your responses to Hank's questions.
And now for something completely different, back to the 2012 Expedition Across Australia. The Expedition finished today and I was able to be there to see David and Don drive across the line. A few pic's below, but many more in this Picasa album link. Some captioned, some not.
Posted on: 2012/4/4 3:24
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
Thursday 5th April 2012
Dropped in at the workshop this morning and found Wade tinkering with Big Red, the carb in particular. Big Red has been hard to start when hot so Wade was taking the opportunity to go over the carb and choke set-up. Wade had arrived back on Tuesday from his sojourn in New Zealand which included the Northern Exposure Rally. Used mate Brian's '46 Clipper which performed flawlessly. Left Wade to it but will be back on Tuesday, after the Easter break. And a link to an article in todays Sydney Morning Herald about the 2012 Expedition Across Australia.
Posted on: 2012/4/4 21:58
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
A whole swag of pic's appeared today in the Drop Box of Expedition Photo's. By some miracle, the thumbs hit the right keys by chance, I managed to import them into an uncaptioned Picasa Album.
Posted on: 2012/4/9 1:19
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
Tuesday 10th April 2012
Just a quick drop in at the workshop. Wade was servicing his Holden Ute, need to keep it up to spec for chasing Packard parts and such. Couple of pic's, below, of the tangible evidence of Wade and Gina's participation in the Northen Exposure Rally. Will need to find a place to mount the badge!
Posted on: 2012/4/10 1:33
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Just popping in
|
Hello Mal, from Wade's Altnerate Workshop. Today Wade took his mobile workshop to Appin to work on Junior's no spark problem. After adjusting the timing and the float in the carburetta Junior finally came to life. More fine tuning and Junior was taken for a test run. Finally Junior is on the road again! Big thanx to Wade for making the trip down to Appin. Cheers Appin's partner ( Annet ).
Posted on: 2012/4/14 1:36
|
|||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
That's great Annet, for the update and the pic's, they leave mine for dead! Good to know that Junior has recovered from his ailments and is up and running again.
Posted on: 2012/4/14 2:17
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
Annet, should have also said it's always good to have another Aussie onboard PackardInfo. And if that dream of an early 30's roadster ever turns into metal don't forget to include it in the Packard Owner's Registry.
Posted on: 2012/4/14 19:48
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Wade's Workshop
|
||||
---|---|---|---|---|
Forum Ambassador
|
Monday 16th April 2012
Spent some time at the workshop. Wade had an Auto-Lite Generator from John, for Junior, he'd picked up on Saturday after he'd brought Junior back to life. John wants to replace the Chrysler generator presently on Junior with this one he'd bought off eBay. Only trouble is the pulley and cooling blades are very bent. A look on the shelf found another pulley and blades, and although not the same can probably be made to fit, but that'll be a job for another day. First thing though, that Wade wanted to do, was take the bearings and other parts for a water pump over to David at Anglade Engineering. Some months back Wade had rebuilt a water pump for a 426 for a guy at Tamworth. There was also a second pump but it's body had split in half which Dave now had had welded up, had machined, had made a sleeve for the new bearings, had made a new shaft and was now ready for the final machining but needed the bearings to do so. Because Wade has plans to go to car show at Tamworth in a couple of weeks time he wanted to get the parts over to Dave so he can finish the machining, so Wade can then take the finished pump with him. And while at Anglade I spotted, of all things, another Packard water pump on the shelf! Turns out it belongs to another guy in the club who needs some machining work done. Back at the workshop Big Red was thoroughly warmed up and then went up on the hoist for an oil change. Wade was taking the opportunity to change the oil, check the fluids, a greasing, etc, etc. All in readiness for the Tamworth trip which is about 250 miles North West. Attach file: (34.51 KB) (35.66 KB) (20.65 KB) (21.06 KB) (37.02 KB) (32.23 KB) (20.37 KB) (45.41 KB) (34.52 KB)
Posted on: 2012/4/16 18:02
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Register To PostTopic is Locked