|
Re: Bob
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
You didn't state the make and model of your Packard but normally one would use a pitman arm removal tool. Any parts store will carry it.
Attach file:  PitmanArmRemover.jpg (23.98 KB)
Posted on: 2022/1/18 22:13
|
|||
|
Stewart Ballard
|
||||
|
||||
|
Re: Bob
|
||||
|---|---|---|---|---|
|
Home away from home
|
Autozone and O'Reilly's will even loan you one, no charge.
Posted on: 2022/1/18 22:25
|
|||
|
||||
|
Re: Bob
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
Quote:
Stewart Ballard wrote: You didn't state the make and model of your Packard....
Posted on: 2022/1/18 22:30
|
|||
|
Mal
/o[]o\ ====  Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this?  Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
||||
|
Re: removing pitman arm on 326 sedan
|
||||
|---|---|---|---|---|
|
Home away from home
|
Ooops! Our Packard is a Third Series SIX 326 Sedan .
What I neglected to say is that the body and sheet metal is NOT removed, so the splash shield is in place and the picture shows the metal 1/2" from the end of the shaft. Absolutely NO way to get a standard puller on it. I am wondering if anyone has used a pickle fork to drive the arm off the shaft?!? Thanks for all the input. Bob
Posted on: 2022/1/18 23:31
|
|||
|
||||
|
Re: removing pitman arm on 326 sedan
|
||||
|---|---|---|---|---|
|
Forum Ambassador
|
I've used a pickle fork to remove Pitman arms, though not on cars as early as yours. Sure, give it a try.
Posted on: 2022/1/19 8:59
|
|||
|
||||
