Hello and welcome to Packard Motor Car Information! If you're new here, please register for a free account.  
Login
Username:

Password:

Remember me



Lost Password?

Register now!
FAQ's
Main Menu
Recent Forum Topics
Who is Online
229 user(s) are online (172 user(s) are browsing Forums)

Members: 1
Guests: 228

DM37, more...
Helping out...
PackardInfo is a free resource for Packard Owners that is completely supported by user donations. If you can help out, that would be great!

Donate via PayPal
Video Content
Visit PackardInfo.com YouTube Playlist

Donate via PayPal




Ultramatic normal behaviors
#1
Home away from home
Home away from home

kevinpackard
See User information
My '54 Panama has an Ultramatic (non-gear start). I assumed that it's operation and behaviors were normal. Then I drove my brother in law's '52 200 and noticed differences right away. That is the extent of my experience with Ultramatics, so I really have no idea what they should be like when they are operating normally.

What I noticed:
-My car seems sluggish/anemic when accelerating. It's not the engine as that seems to have plenty of power. But it seems to take much longer to get up to speed compared to the other car. The 200 seems to have much more pep to it, and that's with a dead cylinder and semi-functioning carb.
-My car will drop into direct drive around 35 mph. It will drop in at lower speeds most of the time if I'm letting off the gas. The 200 drops into direct drive quickly at any speed even on light throttle. It will hold until 35 mph when accelerating hard, but at lighter acceleration it drops at 15, 20, 25.
-The shift in my car feels more pronounced. Not a "slam" but definitely harder.

What's normal on these? Do they typically feel sluggish, or are they supposed to be a little more peppy?

Just looking to see if mine is having issues. Pan was cleaned out, all fresh type F put in. No other additives.

-Kevin

Posted on: 2023/10/17 22:13
 Top  Print   
 


Re: Ultramatic normal behaviors
#2
Home away from home
Home away from home

Ross
See User information
There is only the torque convertor's 2.5:1 multiplication to assist takeoff, so you are never going to leap off the line in high range. Because of the limited torque multiplication, two factors loom large in how an Ultramatic feels: first is rear axle ratio. Your car has a 3.23, the 52 a 3.54 or possibly even a 3.9. That makes a big difference in feel. Second I have found that when these cars are in any way off tune the decreased low speed torque is very noticeable and you have to give a lot of gas. That may come from low compression, late timing, or even how the throttle linkage is adjusted.

Of which, direct engagement speed is a function of throttle opening played against road speed. If the linkage down to the trans is adjusted "high" the trans will upshift later. Of course this is also true if you are giving more gas. 35 is rather high for a normal upshift so you might want to shorten the pull rod to the carb a bit.

According to contemporary roadtests, the cars were of course quicker if you started in low and shifted to high, but not as much quicker as one might think: somewhere between 1.5 and 3 seconds on the 0-60. But the feel is very different especially at takeoff.

Over in Studebaker world many people are incensed that the V8 cars start in second gear in normal driving and complain about takeoff. In actual point of fact none of my cars has the slightest trouble keeping up with the stoplight derby, but neither will you get the burst of acceleration at the outset that makes you feel the car is powerful. Even a Henry J will snap your neck if you play it right but the sensation is very short lived.

Posted on: 2023/10/18 6:48
 Top  Print   
Like (1)
 


Re: Ultramatic normal behaviors
#3
Home away from home
Home away from home

kevinpackard
See User information
I had no idea that the rear axle ratios were different between the two years. I just assumed they were all the same. That would definitely explain some of the difference I felt.

Regarding the tune on the Panama, compression is good across all (145-155), timing should be on but I might need to double check, and I've never adjusted the throttle linkage. The car does seem to run rich (based on plugs) though the mixture screws have been adjusted using a vacuum gauge.

I'll look into adjusting the pull rod to the carb to lower the speed for direct drive. It seems to "hang" a bit as it stands now before it drops into direct.

I've tried the starting in low and switching to high, and was rewarded with a loud and violent clunk. Haven't done it again since.

Posted on: 2023/10/18 11:54
 Top  Print   
 


Re: Ultramatic normal behaviors
#4
Forum Ambassador
Forum Ambassador

HH56
See User information
Quote:
I've tried the starting in low and switching to high, and was rewarded with a loud and violent clunk. Haven't done it again since.

The original Ultramatic was never designed for this manual shift that many were trying to do at the time. The completely unsynchronized actions between low band releasing and high range clutches engaging was one of the issues Packard faced in having one of the first automatics yet still trying to be competitive with other brand transmissions that were newer and coming into use. They actually issued a service kit to try and tame some of the unPackard like problems with the shift but stopgaps were never really successful. You can read about the kit in the Sept, 1953 issue of the Service Counselor. A later article revised the size of the restriction pin to address an issue the kit introduced. If you do try the manual shift again let off on the gas until the high range clutches are fully engaged. Kind of defeats the purpose of the shift but does save wear and tear on the trans.

The GearStart was the end result of all the work to get a real shifting transmission but many feel it was sort of rushed into production and suffered from a lack of testing. Work continued in 55 units renamed the Twin Ultramatic but the high HP and high torque engine didn't help the situation since they added other things to try and tame. Many of those added issues didn't get addressed until the 56 models and by then, while the trans was becoming fairly decent, the time was over.

Posted on: 2023/10/18 12:33
Howard
 Top  Print   
 


Re: Ultramatic normal behaviors
#5
Home away from home
Home away from home

humanpotatohybrid
See User information
Quote:

kevinpackard wrote:
What I noticed:
-My car seems sluggish/anemic when accelerating.


Maybe the problem is you didn't drop a 374 in it.

Posted on: 2023/10/18 13:21
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog
1955 Clipper Super Panama | Registry
 Top  Print   
 


Re: Ultramatic normal behaviors
#6
Home away from home
Home away from home

kevinpackard
See User information
Quote:

humanpotatohybrid wrote:
Quote:

kevinpackard wrote:
What I noticed:
-My car seems sluggish/anemic when accelerating.


Maybe the problem is you didn't drop a 374 in it.


Lol. I'm not expecting a speed demon here, but was just surprised at the difference between two cars with the same engine and transmission.

Posted on: 2023/10/18 13:42
 Top  Print   
Like (1)
 









- The following Google Ad-Sense Advert helps fund the cost of providing this free resource -
- Logged in users will not see these. Please Join and Donate to help support the website -
Search
Recent Photos
Photo of the Day
Recent Registry
Upcoming Events
46th Annual Texas Packard Meet
04/03/2025 - 04/06/2025
Packard Salon - Calling All Twelves
05/27/2025 - 05/29/2025
58th Annual National Meet
05/31/2025 - 06/06/2025
AACA Fall Meet (Hershey)
10/06/2025 - 10/10/2025
South Pacific Packard Club 2026 Rally
03/22/2026 - 03/28/2026
Website Comments or Questions?? Click Here Copyright 2006-2024, PackardInfo.com All Rights Reserved