Re: Engine Oil and Battery Selection
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
I would not if I were you. You will need a battery anyway, may as well get one first thing.
Posted on: Today 20:45
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: Engine Oil and Battery Selection
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Do you have background information on the car, such as general condition, how long it has been inactive, how it ran when last used?
Posted on: Today 21:03
|
|||
|
Re: Engine Oil and Battery Selection
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I suggest turning the engine over two full turns to make sure nothing is stuck. A 1" socket will do the job on the bolt on the front of the crankshaft. That is most easily reached from under the car.
Then don't even put a battery in it for preliminary investigations. Just jump it with good jumper cables from any convenient 12v car or tractor. I wouldn't even turn the key on. Run a hot wire over to the coil--if it doesn't spark as you connect it then either your points are open or are dirty. Use another hot wire to touch the small post on the starter solenoid to make it crank. These cars are not made out of cotton candy. Thus we move the parts cars around all the time. You will do well with an old lawn mower gas tank hanging on the drip rail to feed some fresh gas into the carb. Don't forget to plug the line coming from the fuel pump or you may get an unpleasant surprise if she does fire up.
Posted on: Today 21:42
|
|||
|
Re: Engine Oil and Battery Selection
|
||||
---|---|---|---|---|
Not too shy to talk
![]() ![]() ![]() |
Quote:
That is the crux of it. Depending on whether you ask the previous owner or his uncle whose farm it was parked on since the mid 60s, it was parked because he blew the transmission up OR because it had a serious rod knock. Around here a cheap grade 6V battery is $300 and a mid grade one is $500. If it is just the transmission, that is manageable to move forward. If it has a serious rod knock then the engine has to come out. Given the $$$ to deal with that, something 12V would almost certainly go into it, thus wasting the cost of the 6V battery. I do believe I understand the risk. I will consider my options. As far a turning the crank, I have resurrected a few old engines before. Pull the plugs, give each cylinder a shot of ATF, let that soak while I pull and clean the carb. Gently rock the crank back and forth by the dampener bolt to break it loose (if it was stuck), fresh oil, gas from a gas can with a 2.5psi electric pump, etc. It will get the full "wake up" treatment, but it is stored at a buddy's place an hour from civilization so I need to take anything I might need with me.
Posted on: Today 22:38
|
|||
|