Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Did you have your brake shoes relined, or did you buy a set of relined shoes? If you bought a set of relined shoes, then I would think they are incorrect and too wide. I don't have the shoe width handy, but someone will come around with that spec. If you had your shoes relined, then something else is going on.
(o{}o)
Posted on: 2014/5/15 11:03
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Rear shoes should be 2" wide. It is physically impossible for the axle to move closer to the center because of the thrust block in the diff--unless it got shattered during pulling the drums. But then you would have never gotten the axle end play even withing a quarter inch.
Please show a photo of the backing plate etc.
Posted on: 2014/5/15 11:58
|
|||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
The shoes are original to the car. I did the riveting. Took pains to insure shoes went back to their original positions
Posted on: 2014/5/15 12:48
|
|||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Are u sure its the shoes hitting???? The shiny rivet appears too close to centre to have shoe interfetence. Something else maybe????
Posted on: 2014/5/15 13:31
|
|||
VAPOR LOCK demystified: See paragraph SEVEN of PMCC documentaion as listed in post #11 of the following thread:f
https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=7245 |
||||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
picture left rear assembly:
Posted on: 2014/5/15 13:55
|
|||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Looks okay except you have the long lining (secondary) on the front. This should not be causing your problem, but the shorter lined, primary shoe, should be on the front.
(o{}o)
Posted on: 2014/5/15 14:21
|
|||
We move toward
And make happen What occupies our mind... (W. Scherer) |
||||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Forum Ambassador
|
Please post a picture of each lining showing the rivets.
Is the front pin of the wheel cylinder positioned properly?
Posted on: 2014/5/15 14:27
|
|||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Looks like the front wheel cylinder pin is not in the shoe slot!
Posted on: 2014/5/15 16:29
|
|||
|
Re: 55 400 brake shoe interferance
|
||||
---|---|---|---|---|
Home away from home
|
Yes the metal edge of both shoes, on the drum side contacted the drum. This is happening on both the left and right sides
Posted on: 2014/5/15 16:47
|
|||
|