Packard Forum Index » Pre-War (1899-1942)

Hello everybody, I need some new rear fender bolt for my 1940 Packard 110, but I don't know where to buy them.
Can somebody tell me where I can buy them?

Thank you in advance.

Attach file:

---

  (198.28 KB)

Restoration Specialties 814-467-9842 You may have to send old bolt so it can be matched.

Some discussion in this thread
Click to View->https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=10110&forum=3&post_id=106661#forumpost106661

Can't tell size from the picture but the parts manual lists #325724 a 5/16-10 x 7/8 used on the fenders which sounds & looks like it may be close to the photo. If that's it, Kanter may have them.

If it is correct size, check out AMK productshttp://www.amkproducts.com/default.htm and under the PDF catalog, download their Screws, tapping (sheet metal) pages 74-91.

At the bottom of page 76 are a couple that might do the job although not exactly the same as the photo. Some others types in that size range are on other pages as well as different sizes if it is not 5/16.

McMaster-Carr has blunt end 5/16-12 in 3/4 and 1" length without the washer. Depending on what it threads into, those may also work.

Thank you everybody for your replies, I really appreciate.

Howard, it looks like the size matches what you mentioned.
Time to order some bolts now...