Re: Stromberg EE-23 carb drips......
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Assuming the fuel bowl vent is clear, biggest suspect would be the needle and seat, despite the fact that it's new. If the needle/seat is one of those Viton-tipped needles, I'd replace it with a steel/brass metallic set, or one of Daytona's new style. 5 psi fuel pressure seems mariginally high for the OEM-type mechanical fuel pump which typically is about 3 to 4-1/2 psi but even so a good needle and seat should hold that pressure.
PS - you should also check to insure that the automatic choke fully opens as the engine warms; it's not the least uncommon for some fuel to drip from the manifold drain tube during warm-up - that's why it's there.
Posted on: 2013/11/30 9:33
|
|||
|
Re: Stromberg EE-23 carb drips......
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Try turning ur idle down.
Posted on: 2013/11/30 9:52
|
|||
|
Re: Stromberg EE-23 carb drips......
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Dear needy36:
That is symptomatic of clogged main jet air bleeds and requires somebody with the special jet wrench to remove and clean them, and experience to avoid breaking the casting. Thus you need to send the unit to either Daytona Parts in Florida, The Carburetor Doctor in Canada, or Classic Carburetors in Arizona. They should be able to help.
Posted on: 2013/11/30 10:25
|
|||
|
Re: Stromberg EE-23 carb drips......
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Tim, I fully agree with you about the air bleeds but had (perhaps incorrectly) discounted that with the comment that the unit had been "professionally rebuilt". But that expression covers a lot of territory, a true carb professional would have serviced the air bleeds, so I guess we have to wait and see.....
To my mind, Daytona still stands at the top of list when it comes to carburetor rebuilds.
Posted on: 2013/11/30 11:13
|
|||
|