Packard Forum Index » Pre-War (1899-1942)

After examining the Bijur system, I was happy to find it is almost all in place. There is one length of line missing between the right rear Tee-fitting and the three-way connector for the line leading to the right rear spring hinge bolt.

I understand 3/16" refrigeration tubing can be readily obtained. Need to find what is described in the Service Parts List as a "Lubricator Tube Union Nut (Junction End)" for fitting the tubing to the Tee-fitting. (The other end of the tube is soldered to the three way connector.) Neither Bruce Blevins nor Classic & Exotic offer this part. Is it a common fitting, perhaps used in refrigeration, that can be obtained elsewhere?

Although I am not able to get to my parts for a while most of the tubing and fittings came off of my 1930 chassis in good condition. If you are still in need I'll see if I can help you out.

Sherlock,

You can always use a 3/16" brass compression fitting tee. If it is out of sight no one will ever know. I used several on my '32 901.

Thank you gents!