Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Home away from home
|
Yes, you don't have to pull the trans. The tail shaft housing unbolts like a normal trans. However, if it is really pouring out it may not be the seal, but the speedometer gear being installed backwards. To check, tape some paper towel over the vent on top of the trans and drive the car. If it gets soaked, the gear is installed backwards.
Posted on: 2020/3/30 0:09
|
|||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Forum Ambassador
|
G'day Chilidog,
to PackardInfo. And, I invite you to include your '50 23rd Series Packard in the Packard Owner's Registry.
Posted on: 2020/3/30 0:25
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Just popping in
|
I'm on it! Thanks for the help & advice!
Posted on: 2020/3/30 10:52
|
|||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Just popping in
|
I have registered. Thank you
Posted on: 2020/3/30 10:53
|
|||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Forum Ambassador
|
As I recall, the rear mount is on the tailshaft so if you remove it to change the seal you will need to have something like a floor jack or similar under the rear of engine or transmission pan for support while the tailshaft is removed. If you go under the pan be sure to use a wide block of wood to distribute the load.
Posted on: 2020/3/30 11:02
|
|||
Howard
|
||||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Just popping in
|
Great advice! Thank you very much
Posted on: 2020/3/30 11:19
|
|||
|
Re: Ultramatic rear bearing seal replacement
|
||||
---|---|---|---|---|
Forum Ambassador
|
Quote:
Chilidog wrote: I'm on it!....
Posted on: 2020/3/30 14:48
|
|||
Mal
/o[]o\ ==== Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|