Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Can you disconnect the mechanism and move it up-and-down by hand? It might be obvious where it's binding.
Posted on: Yesterday 16:34
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Does not seem to be issue of binding….retracts smoothly. It will go up if someone is holding the button down and i do manual assist.
Not something that you would want if you were alone and had reason to raise the top . It functioned perfectly before but the car gets little use. Was just curious if anyone had a top motor start to fail. I thought that maybe the battery was low or generator output did not have enough juice but same result with charger attached at :40:@mps.
Posted on: Yesterday 18:05
|
|||
|
Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
Raising and lowering a convertible top often has little to do with how well it will operate. But yes, like most automotive systems, it is wise to cycle it periodically. But the most important thing is to properly maintain the top and power mechanisms. Was this system completely flushed and filled when assembled? Was this system burped? Raising the top is always the time when the power hydraulic system is stressed the most. So yes, it makes sense that problems raising are more likely than lowering. What kind of hydraulic lines do you presently have fitted between the pump and the rams? IF the lines are the plastic type you can see through, have someone operate the top switch while you observe the lines. • Check for bubbles • Check for air pockets • Check for continuous fluid on a raise cycle. • IF A V-8 PACKARD... be sure to have transmission fluid in the system rather than brake fluid. • Check closely for leaks in ram seals, reservoir, pump itself. IF you still have old rubber hydraulic lines obviously you won't be able to perform these steps... so check the rams with your top in the raised position, Disconnect the rods from the topstack frame and (being prepared with catch pans) check your lines individually. IF no bubbles or air pockets,: • check reservoir for fullness, clean, no blockages. • Disconnect shiny rods on rams from the topstack frame... • Have someone operate the switch while you observe BOTH rams and rods. Rods should BOTH extend and retract evenly. IF not, you either have a blocked line, bad seal, or defective ram. • IF BOTH RAM RODS malfunction during RAISE or LOWER cycles, the problem is either in the pump or lines of BOTH rams are defective. IF you are not getting pumping or suction at each line end– WITH a properly filled reservoir– (OR uneven suction) then the problems are in the lines. Replace them ALL. IF you are getting no pumping or suction OR sporadic at all found connections, then the problem is the pump. Replace it. AND... ALWAYS make certain that your shiny rods on the rams indeed are clean, shiny and no rust! Rust tears rubber seals. Dirt can do likewise. NEVER, EVER attempt to operate your convertible top by hand. This design was counterbalanced and meant to operate as such. Furthermore, pressure in the wrong positions can cause segments of the frame to crack, bind or completely snap off. The material of these segments is brittle and does not lend itself well to being welded once broken. Don't do it! Procedures for proper power convertible top were listed some time ago in the Packard Club's Cormorant News Bulletin.
Posted on: Yesterday 18:24
|
|||
|
Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
And before arbitrarily replacing the pump you might also check pressures as described on page 28 in the body section of the 55-6 service manual.
Posted on: Yesterday 18:53
|
|||
Howard
|
||||
|
Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
Important Note: The ancient factory service manual specifications may not be applicable if newer components like pump or plastic lines are presently installed.
Posted on: Yesterday 21:40
|
|||
|
Re: Convertible top- 1955 Caribbean
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Leeedy and.Howard— As usual you give sound advise and I thank you for your imput .
The top operation is confusing me since it worked fine for years …granted that the cars has had limited use and raising and lowering the top has probably been limited to a few times each year that the car comes out from under the car cover. During the rebuild I purchased all new parts …rams, lines and pump from Hydro E Lectric which has supplied the same parts for numerous convertibles that I own or have owned over the years. Their instructions were followed during this installation and aside from my initial error in having the top fitting to the rear of the lift cylinder on the passenger side reversed which created a serious problem reviewed here a number of years ago ( the fitting on the passengers side lift cylinder impacted the wheel well and would not alllow the roof to drop into the boot ), it functioned well. I will go back over your suggestions and hope that I do not need to change the pump. I have left a message with Hydro E Lectric and will let you know their response. I used to enjoy crawling under dash boards and lying in trunks but age makes those postures less tolerable.
Posted on: Yesterday 23:47
|
|||
|