Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Just popping in
|
Twice to the floor in all instances for my 39!!
Posted on: 2015/8/19 23:50
|
|||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
Turn the electric fuel pump on, let it pump for about 10-20 seconds, pump accelerator twice and they start right up.
Posted on: 2015/8/20 8:40
|
|||
I can explain it to you but I can't understand it for you
Bad company corrupts good character! Farming: the art of losing money while working 100 hours a week to feed people who think you are trying to kill them |
||||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Forum Ambassador
|
In all cases you give, I just lightly tap the gas pedal once to set the automatic choke, turn the key and hit the starter - usually starts within 1/2 to 2 revolutions. Same process with either the 34 or the 56.
No electric fuel pumps here, if the car has sat for 14 days or so, I pump the gas pedal lightly to set the choke and then two or three times while it's cranking - starts very quickly. I understand you can't do this on cars with the Carter carburetor starter switch.
Posted on: 2015/8/20 8:50
|
|||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
If it's been sitting for a long time [weeks], I'll switch the electric pump on for about 15 seconds. Then I give the accelerator 3 half pumps [a full pump would activate the starter] and then to the floor and she starts right up ... every time. This applies to the '50.
Posted on: 2015/8/20 8:51
|
|||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
Does the starter engage if the ignition is off????
Posted on: 2015/8/20 10:03
|
|||
West Peterson
1940 Packard 1808 w/Factory Air 1947 Chrysler Town and Country sedan 1970 Camaro RS packardinfo.com/xoops/html/modules/newbb/viewtopic.php?topic_id=4307&forum=10 aaca.org/ |
||||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
When I reinstalled the engine I also installed a glass float bowl filter just prior to the carburetor float. I noticed after the car had sat for 3 days that the fuel in the glass bowl was only about one quarter full. This car does have an electric pump so that makes refilling the carburetor float bowl easy.
It seems that to pump the gas pedal twice with the ignition off and then hold the accelerator pedal all the way down after the second pump, and then turn the ignition switch to the right it seems the car starts up fine. With a hot engine it seems that pushing the gas pedal down makes it start a bit rich. Thanks for the suggestions!!!
Posted on: 2015/8/20 10:45
|
|||
Bill,
Dedicated to keeping the man who owns one on the road!!! |
||||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Forum Ambassador
|
With a hot engine it seems that pushing the gas pedal down makes it start a bit rich.
Perhaps so, though if the automatic choke unloader is properly adjusted it should activate at full throttle depression.
Posted on: 2015/8/20 10:57
|
|||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
Quote:
No, but then the electric pump is off too. I suppose I could; ignition on, prime, ignition off, pump once to the floor, ignition on, again to the floor to start... but that seems a bit involved. If the car hasn't been sitting for a week or more, I just get in, turn the key on and start the car. No drama.
Posted on: 2015/8/20 16:37
|
|||
|
Re: What Is Your Engine Start Procedure?
|
||||
---|---|---|---|---|
Home away from home
|
Ignition off, one pump, ignition on and floor the pedal ( carb starter switch) and the car is running.
Posted on: 2015/8/20 20:28
|
|||
[url=h
|
||||
|